TM 5-6115-629-14&P
Figure 4-4. External Fuel Line Connection.
Section II. MOVEMENT TO A NEW WORKSITE
4.3.
Dismantling for Movement. Because the power plant is designed to be mobile, a minimum
amount of effort is required to relocate to a new worksite. Procedures are as follows:
a.
b.
c.
d.
e.
f.
Disconnect power plant from system or equipment being powered.
Disconnect ground cables from source of ground and GROUND TERMINAL studs on both power
units. Roll up cables and store in accessory boxes.
Using slide hammer, remove ground rods. Disassemble, clean, and stow ground rods in
accessory boxes.
Disconnect power plant from external fuel sources, if applicable.
Disconnect ground wires between switch box and GROUND TERMINAL studs on power units.
Roll up ground wires and store in accessory boxes.
Disconnect power cables from both power units and from switch box. Roll up cables and
secure each to roadside fender of respective power unit using straps provided.
4-7
