TM 5-6115-628-14&P
CHAPTER 5
INTERMEDIATE (FIELD) (DIRECT SUPPORT AND
GENERAL SUPPORT) MAINTENANCE INSTRUCTIONS
Section I. INTRODUCTION
5-1.
General. This chapter contains Intermediate Direct Support and General Support level mainte-
nance procedures for components of the M200A1 trailer added when the trailer is used as part of the
AN/MJQ-15 power plant. These components are not covered in the overall trailer maintenance
manual. For all other intermediate direct and general support maintenance procedures on the trailer,
refer to TM 9-2330-205-14&P. For intermediate direct and general support maintenance procedures
on the generator sets, refer to TM 5-6115-464-34.
WARNING
Before performing any maintenance that requires climbing on or under trailer,
set trailer handbrakes, chock wheels, and lower rear leveling jacks. Injury to
personnel could result from trailer suddenly rolling or tipping.
Section Il. MAINTENANCE OF POWER PLANT TRAILERS.
5-2. Step and Fender Repair. Repair of the front and rear steps and the fenders is limited to straight-
ening, welding and repainting. If required, repaint in accordance with MIL-T-704, Type F, Color
Green, No. 383 of MIL-C-46168.
5-3. Accessory Box Repair. (See figure 5-1.) The accessory boxes are repaired by replacing the
latch and strike assemblies. The boxes themselves may be straightened, welded and repainted. If
required, repaint in accordance with MIL-T-704, Type F, Color Green, No. 383 of MIL-C-46168.
Replace latch and strike assemblies as follows:
a. Grind off or drill out solid rivets (1, figure 5-1) securing latch and strike assembly (2) to
accessory box (3).
b. Position new latch and strike assembly (2) on accessory box (3) and secure with solid
rivets (1).
c. Touch up with paint as required.
Figure 5-1. Accessory Box Repair.
5-1
