TM 5-6115-628-14&P
(4) Remove spacer (9) and insert (10) from plug shell (8).
(5) Remove contact(s) (11) being repaired or replaced from spacer (9) and insert (10).
Unsolder contact(s) (11) from wire(s) (12).
NOTE
If contact is crimped onto wire, or if wire is broken, do steps (6) through (8).
(6) Cut contacts (11) off wires (12).
(7) Strip back cable jacket to expose more of individual wires.
(8) Cut wires to equal length. Strip and tin wires in accordance with procedures given in
technical manuals referenced above.
Figure 5-5. Power Cable Repair.
b. Installation.
(1) Solder replacement contact(s) (11) on wire(s) (12).
(2) Aline and insert contact(s) (11) into spacer (9) until contacts are fully seated.
5-6
