TM 5-6115-627-14&P
(4) Remove three screws (16), three flat washers (17) and three nuts (18). Separate rear step bracket (4)
from step (11).
b. Installation.
(1)
(2)
(3)
(4)
(5)
If rear step bracket (4) was removed from step (11), align bracket and step (11) and install three screws
(16), three flat washers (17) and three nuts (18).
Position rear step (11) on trailer frame (6).
Secure rear step (11) to trailer frame (6) with two screws (8), four flat washers (9) and two nuts (10).
Secure rear step (11) to fender (15) with five screws (12), ten flat washers (13) and five nuts (14).
Align two mounting holes in rear step bracket (4) with holes in trailer frame (6) under taillight (7) and
(6)
(7)
insert two screws (1).
Slide S-hook at chain end of platform anchor (5) onto threaded end of lower screw (1) inside trailer
frame (6).
Install one flat washer (2) and one nut (3) on each screw (1) and tighten.
4-23. Fender Replacement. (See figure 4-10.) The fenders on the trailer assemblies are symmetrical, and
replacement procedures are the same for all.
a. Removal.
(1)
(2)
(3)
(4)
Remove five screws (1, figure 4-10), ten flat washers (2) and five nuts (3) securing fender (4) to trailer
frame (5).
WARNING
There are five sets of hardware securing fender to rear step and seven sets of hardware
securing fender to front step. This hardware should be removed in sequence from trailer
frame outward. In this way, last two screws on front and rear lower fender edge will
support fender until you are out from underneath.
Remove six screws (6), 12 flat washers (7) and six nuts (8) securing fender (4) to front step (9). Leave
one outside set of hardware in place.
Remove four screws (10), eight flat washers(11) and four nuts (12) securing fender (4) to rear step (13).
Leave one outside set of hardware in place.
WARNING
Support fender while removing remaining two sets of hardware. When hardware is
removed, fender will drop.
Remove one screw (6), two flat washers (7) and one nut (8) securing fender (4) to front step (9).
4-23
