TM 5-6115-627-14&P
(3) Identification plate.
(a) Location. This plate is located below ground stud above roadside front step.
(b) Content.
GROUND TERMINAL
(4) Wiring diagram designation plate.
(a) Location. This plate is located inside switch box access cover.
(b) Contents. (See figure 4-14).
(5) Identification plate.
(a) Location. This plate is located on connector side of switch box.
(b) Content.
SWITCH BOX
NSN 6110-01-264-2069
(6) Instruction Plate.
(a) Location. This plate is located on the outside of switch access door, under generator indicator lights.
(b) Content.
OPERATING INSTRUCTIONS
A.
B.
c.
PRIOR TO OPERATION, READ INSTRUCTION MANUAL FURNISHED WITH THE POWER
UNIT (GENERATOR SET), INCLUDING APPLICABLE REVISION SHEETS.
INSURE GENERATOR CIRCUIT BREAKERS AND SWITCH BOX SWITCHES ARE IN THE
“OFF” POSITION.
TO OPERATE ONE UNIT, THIS PROCEDURE SHOULD BE FOLLOWED:
1.
2.
3.
4.
CONNECT ALL NECESSARY CABLES TO THE GENERATOR AND SWITCH BOX
ASSEMBLY.
BRING GENERATOR UP TO RATES SPEED, VOLTAGE AND FREQUENCY.
CLOSE GENERATOR CIRCUIT BREAKER.
MOVE SWITCH BOX SWITCH, CORRESPONDING TO GENERATOR USED, TO “ON”
POSITION.
1-5
