TB 9-6115-642-13
WIRING HARNESS MAINTENANCE.
This task covers:
a. Inspect
d. Repair
b. Test
e. Replace
c. Remove
f. Install
INITIAL SETUP
Tools
Equipment Conditions
Tool Kit, General Mechanic's
Reference
(item 1, appendix B)
Multimeter (item 5, appendix B)
Generator shut down, TM 9-6115-642-10
Heater shut off, Paragraph 2-4.1.c
Materials/Parts
None
WARNING
Make sure generator set is shut down before performing any
maintenance. Failure to observe this warning could result in severe
personal injury or death.
INSPECTION
Inspection is limited to visual inspection of components. Check for damaged and frayed wiring.
TEST
Test wiring for continuity. Replace any open or broken wires or connectors.
REMOVAL
1.
Refer to Figure 4-27 and tag all leads on wiring harness to be removed.
2.
Disconnect all leads and plugs. Remove wiring harness.
REPAIRMENT
Repair consists of replacing wires, connectors, and terminals. Follow standard shop practice in performing all repairs.
REPLACEMENT
1.
Perform steps 1 thru 2 of removal.
2.
Perform steps 1 thru 2 of install, substituting new wiring harness for the defective one.
INSTALLATION
1.
Position wiring harness in place.
2.
Refer to Figure 4-27 and connect leads and plugs.
