Wire # 310A12
Wire # 310B12
Figure 4 CB1/BCT Bracket Assembly
11. Fish the other end of the wire # 310A12 through the bracket into the battery charging current
transformer as shown in figure 4. Install 10-12 gauge, 3/8 inch stud size lug terminal to the end
of the wire.
12. Attach CB1/BCT bracket assembly to the alternator using the existing hardware as shown in figure 5.
13. Install 3/8 inch stud size, lug terminal to the positive terminal on the battery charging alternator, as
shown in figure 5. If both procedures have been followed properly, then there should be two wires, wire
#165C16 and wire #310A12, attached to the positive terminal of the battery charging alternator.