TB 11-6115-741-24
Wire # 310B16
Current
Current
Transformer
Transformer
Bracket
Wire # 165C16
Figure 3 Alternator compartment
4. Remove the current transformer bracket from the back of the alternator, see figure 3. Remove the
battery charging current transformer from the bracket and discard the bracket.
5. Using the Bracket Drawing in Figure 7, fabricate the new bracket. Install the battery charging
current transformer, in the same orientation, on the new bracket.
6. Measure and cut a 41 inch piece of 12 gauge wire (88-20540-6). Label wire "310B12" close to both
ends. On one end, install a 10-12 gauge, 0.164 inch stud size lug terminal. On the other end, install a 10-
12 gauge, 3/8 inch stud size lug terminal.
7. Install the 0.164 inch stud size lug terminal of wire # 310B12, on the load terminal of the circuit
breaker (CB1) so that the lug terminal is parallel to CB1 on the label side as shown in figure 4.
8. Install a 10-12 gauge 0.164 inch stud size lug terminal to one end of the 12 inch wire. Label wire
"310A12" close to both ends.
9. Install the 0.164 inch stud size lug terminal of wire #310A12, on the line terminal of CB1 so that the
lug terminal is perpendicular to CB1 on the label side, as shown in figure 4.
10. Install CB1 into side hole of the battery charging current transformer bracket as shown in figure 4.
6-10
