TM 5-6115-640-14&P
(3)
Remove lockwasher (10), nut (11) and internal-tooth lockwasher (12) and pull terminal (8) off terminal
board (13).
(4)
Remove 6 nuts (17), 6 lockwashers (16), 12 washers (15), and 6 screws (14) and take terminal board (13)
and gasket (18) off switch box (5).
b.
Installation.
(1)
Position gasket (18) and terminal board (13) on switch box (5) and fasten with 6 screws (14), 12 washers
(15), 6 lockwashers (16), and 6 nuts (17).
(2)
Insert alignment tip of terminal stud (8) through small hole of terminal board (13) and into switch box (5).
(3)
Install internal-tooth lockwasher (12) and nut (11) on terminal stud and tighten against inside of terminal
board.
NOTE
Observe identification tags when installing internal wires.
(4)
Slide lockwasher (10) and terminal lug(s) of wire(s) (9) on terminal stud (8).
(5)
Install lockwasher (7) and nut (6) on terminal stud and tighten.
(6)
Position cover (4) on switch box (5) and secure with 16 screws (1), lockwashers (2) and flat washers (3).
Section XI. ELECTRICAL LEADS (WIRING) MAINTENANCE
4-22. WIRING MAINTENANCE.
This Task covers
1.
Test
3.
Installation
2.
Removal
Initial Setup:
1.
Tools - Multimeter AN/PSM-45 (6625-01-139-2512)
- General Mechanics Tool Kit (5180-00-177-7033)
2.
Materials/Parts - Electrical Leads (97403); 13212E3567-1/-2/-3/-4
4-31
