ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
5-49
FIGURE 5-10. END BELL REMOVAL
NOTE
It may be necessary to use a lifting device to raise and align end bell with
generator.
(3)
Position end bell (16), with exciter stator (22) attached, on generator housing (33) while pulling
slack of wires F1 and F2 through front of generator housing. Secure end bell with washers (15),
lockwashers (14) and bolts (13). Torque bolts to 59-61 inch-pounds (6.7-7.0 Nm).
(4)
Tighten lead clamp assembly (3) at front of generator housing (33), ensuring generator leads are
clamped securely.
(5)
Install louvered cover (12), top cover (7), lockwashers (6), and bolts (5) on end bell (16).
(7)
Install rear housing panel. Refer to paragraph 4.7.5.
(8)
Connect negative battery cable to battery, and close BATTERY ACCESS door.