Table G-2. Crimp Tools

APPENDIX G ILLUSTRATED LIST OF MANUFACTURED ITEMS - TM-9-6150-228-13P_179

SECTION II. MANUFACTURED ITEMS PART NUMBER INDEX

TM-9-6150-228-13P Generator Set Skid Mounted Tactical Quiet 60 Kw 50/80 and 400 Hz MEP-806B (50/60 Hz) MEP-816B (400Hz) Manual
Page Navigation
170

TM 9-6150-228-13&P G.2 GENERAL INFORMATION - CONTINUED. Table G-2. Crimp Tools Item No. Nomenclature Size Part Numbers 1 Removal Tool, Pin/Socket M81969/27-3 1 MS90562-3 2 Removal tool, pin/socket 4 TP201315-04 3 Removal tool, pin/socket M81969/274 6 MS90562-6 4 Installer tool, pin/socket 4 M81969/17-07 5 Crimp tool system, pneumatic 400-1-200-5KL - M25520/23-01 5a Locator, pin/socket 4297-5 4 M22520/23-12 5b Crimping die, pin/socket 414DA-4N 4 M25520/23-04 5c Locator, pin/socket 4297-3 0 M22520/23-13 5d Crimping die, pin/socket 414DA-1/on 0 M25520/23-05 5e Crimping die, pin/socket 4297-6 6 M22520/23-10 5f Crimping die, pin/socket 414DA-6N 6 M22520/23-03 b. Removal of Cable Insulation. When installing electrical connectors to cable ends, cut and remove cable jacket and insulation as follows:. (1) 100-amp. 8-wire cables. Do not cut insulation on individual wires when cutting cable jacket. (a) Carefully cut and remove 3-1/2 inches (89 mm) of outer cable jacket from end of cable. (b) Carefully cut and remove 7/8 inch (22 mm) of conductor insulation from each conductor. (c) Attach electrical connector to cable end. (2) 60-amp. 5-wire cables. Do not cut insulation on individual wires when cutting cable jacket. (a) Carefully cut and remove 3-1/2 inches (89 mm) of outer cable jacket from end of cable. (b) Cut off 12 inch (13 mm) from phases A, B, C and neutral conductor (the four large conductors). (c) Carefully cut and remove 7/8 inch (22 mm) of conductor insulation from end of each conductor. (d) Attach electrical connector to cable end. G-2

Privacy Statement
Press Release
Contact