TM 9-6150-228-13&P APPENDIX G ILLUSTRATED LIST OF MANUFACTURED ITEMS SECTION I.   INTRODUCTION G.1 INTRODUCTION. a. This appendix includes complete instructions for making items authorized to be manufactured or fabricated at direct support maintenance level. b. A part number index in alphanumeric order is provided for cross-referencing the part number of the item to be manufactured to the figure which covers fabrication criteria. c. All  bulk  materials  needed  for  manufacture  of  an  item  are  listed  by  part  number  or  specification  number  in tabular list on the illustration. G.2 GENERAL INFORMATION. a. Connector Crimping Tools.  The cable and wall mount connectors have pin contacts (male) or socket contacts (female) that attach to the wires with a four-indent crimp.  Table G-1 identifies which tools to use to crimp each type and size of connector contact.  Table G-2 lists the various insert,  removal,  locator,  and crimp tools you need to repair both cable and wall mount connectors. Table G-1.  Crimp Tool Selection Chart NOTE Cable-type connectors mount on cable ends.  Wall-type connectors mount on the power distribution panel.  Use needle-nose pliers to install pins or sockets which do not have a special installation tool listed. Table G-2 Item No. Connector group/type Pin/Socket size Remove tool Installer tool Locate tool Crimp tool 100-amp,  8-wire connectors: Cable-type,  large pin/socket 0 1 – 5c 5d Cable-type,  small pin/socket 6 3 – 5e 5f Wall-type,  large pin/socket 0 1 – 5c 5d Wall-type,  small pin/socket 6 3 – 5c 5f 60-,  amp,  5 wire connectors: Cable-type,  large pin/socket 4 2 4 5a 5b Cable-type,  small pin/socket 6 3 – 5e 5f Wall-type,  large pin/socket 4 2 4 5a 5b Wall-type,  small pin/socket 6 3 – 5e 5f G-1