FIGURE 2-1.
TM 9-6150-226-13
1. IF CIRCUIT BREAKER IS IN TRIPPED POSITION, IT INDICATES THAT BREAKER HAS BEEN
SUBJECTED TO AN OVERLOAD CONDITION. WAIT TWO MINUTES BEFORE RESETTING
BREAKER. TO RESET BREAKER, IT MUST BE PUSHED TO “OFF” POSITION BEFORE TURNING
TO “ON”.
2. IF CIRCUIT BREAKER IS IN “OFF” POSITION, IT INDICATES THAT IT HAS NOT BEEN OPERATED
OR HAS BEEN SUBJECTED TO SEVERE OVERLOAD.
3. IF BREAKER TRIPS AGAIN AFTER RESETTING, THE FAULT MUST BE CLEARED BEFORE SAFE
OPERATION CAN BE RESUMED. IF NO FAULT IS DETECTED, CHECK OR REPLACE BREAKER.
2-5
