TM 9-6150-226-13
Table 3-1.
OPERATOR TROUBLESHOOTING (cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2.
CIRCUIT BREAKER SUPPORTING USERS LOAD REPEATEDLY TRIPS.
CAUTION
Do not block circuit breakers in ON position.
Excessive
current will damage DISE and PDISE equipment.
Step 1.
Recalculate users load requirements for circuit that is
tripping.
a.
If users total load requirements exceed circuit breaker
rating,
redistribute
load
by
running
an
additional
extension and branch circuit to users equipment.
b.
If users total load requirements are less than circuit
breaker rating and circuit breaker still trips, notify next
higher level of maintenance.
3.
USER S EQUIPMENT OPERATES ERRATICALLY OR TOO SLOWLY.
Step 1.
Check generator for proper output.
Refer to proper TM and adjust generator.
Step 2.
Check cables and connectors for proper connections.
Properly connect cables and connectors.
Step 3.
Calculate voltage loss due to cable length (table 1-3).
Use shorter cable as necessary to reduce voltage loss.
Section III.
MAINTENANCE PROCEDURES
Section Index
Subject
Repair
Inspection
Introduction Maintenance
Page
3-6
3-6
3-6
3-4
