TM 9-6115-730-24
0085
LONG TERM STORAGE - Continued
14. Disconnect manifold in hose from intake manifold (WP 0067, Step 16). Set DEAD CRANK SWITCH to
CRANK to turn over engine, use a pneumatic oil gun to spray preservative oil (WP 0126, Item 32) into air inlet
for one minute. Release dead crank switch. Connect manifold in hose.
15. Remove air cleaner cover and both filter elements (WP 0071) Set DEAD CRANK SWITCH to CRANK to turn
over engine, use a pneumatic oil gun to spray preservative oil (WP 0124, Item 32) into air cleaner housing for
30 seconds. Release dead crank switch. Install both filter elements and air cleaner cover.
16. Allow muffler to cool. Use a pneumatic oil gun to spray preservative oil (WP 0124, Item 32) into exhaust outlet
housing for 30 seconds.
17. On left side of TQG, place a suitable container under the fuel drain. Remove cap from fuel drain and open the
fuel drain valve. Completely drain the fuel tank. Close fuel drain valve and install cap to first locking position.
18. Completely drain cooling system (WP 0068).
19. Apply preservative oil (WP 0124, Item 32) to all hinges and latches on the TQG.
20. Disconnect all battery cables from batteries (WP 0050). Secure battery cable terminals away from the
batteries with tape. Apply petroleum jelly to all battery terminals.
21. Close all doors.
22. Prepare tag with the following statements: "CRANKCASE FILLED WITH PRESERVATIVE OIL (MIL-PRF-
21260, GRADE 30). GOOD FOR OPERATION UNTIL FIRST REQUIRED OIL CHANGE."
23. Prepare tag with the following statements: "COOLING SYSTEM DRAINED. FILL WITH PROPER
ANTIFREEZE MIXTURE BEFORE OPERATION."
24. Prepare tag with the following statements: "FUEL SYSTEM PRESERVED WITH PRESERVATIVE OIL (MIL-
PRF-21260, GRADE 10W). DRAIN FUEL LINES BEFORE OPERATING. CHANGE FUEL FILTER AFTER
ONE HOUR OF OPERATION.
25. Place all the above tags on the control panel and secure with tape.
26. Secure all doors with tape.
END OF TASK
END OF WORK PACKAGE
0085-4
