TM 9-6115-730-24
0071
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left rear doors.
CAUTION
Do not twist filters or damage may occur.
3. Unfasten wing nut (Figure 1, Item 1) and remove outer filter (Figure 1, Item 2) from air cleaner housing
(Figure 1, Item 3).
4. Remove C-clip (Figure 1, Item 4).
5. Remove cotter pin (Figure 1, Item 5), indicator nut (Figure 1, Item 6), and inner filter element (Figure 1,
Item 7).
6. Reset indicator nut (Figure 1, Item 6) by applying compressed air to rear of the indicator nut while sealing the
front opening of nut.
END OF TASK
CLEANING
WARNING
Cleaning with compressed air can cause flying particles. When using compressed air, wear
protective glasses and use clean, low pressure air, less than 30 psi (208 kPa). Failure to comply
can cause eye injury to personnel.
1. If not excessively dirty, clean filter elements (Figure 1, Item 2) and (Figure 1, Item 7) with low pressure (less
than 30 psi) compressed air.
2. Wipe interior of housing (Figure 1, Item 3) with clean lint-free cloth.
3. Replace filter elements when damaged or when they cannot be cleaned.
END OF TASK
INSTALLATION
1. Install inner filter element (Figure 1, Item 7), indicator nut (Figure 1, Item 6), and cotter pin (Figure 1, Item 5).
2. Install C-clip (Figure 1, Item 4), outer filter element (Figure 1, Item 2), and hand tighten wing nut (Figure 1,
Item 1).
3. Close left rear doors.
0071-2
