TM 9-6115-730-24
0057
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch
is OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open left front door, left rear doors, and right rear doors.
NOTE
Cut tiedown straps as required.
3. Remove water separator filter drain (Figure 1, Sheet 1, Item 1) from water separator filter (Figure 1, Sheet 1,
Item 3).
4. Place drain pan under the water separator filter (Figure 1, Sheet 1, Item 3). Turn plug (Figure 1, Sheet 1,
Item 2) counterclockwise to open the self ventilated drain. Drain the fuel from the water separator filter, then
retighten plug (Figure 1, Sheet 1, Item 2).
5. Disconnect hose assembly (Figure 1, Sheet 1, Item 4) from fuel pickup tube assembly (Figure 1, Sheet 1,
Item 5) and from water separator filter drain (Figure 1, Sheet 1, Item 1).
6. Disconnect swivel ball fitting (Figure 1, Sheet 1, Item 6) from hose (Figure 1, Sheet 1, Item 8) by removing
clamp (Figure 1, Sheet 1, Item 7).
7. Disconnect hose (Figure 1, Sheet 1, Item 10) from female connector (Figure 1, Sheet 1, Item 9) by removing
clamp (Figure 1, Sheet 1, Item 7).
8. Disconnect female connector (Figure 1, Sheet 1, Item 9) from swivel ball fitting (Figure 1, Sheet 1, Item 6).
9. Disconnect hose (Figure 1, Sheet 1, Item 8) from water separator filter (Figure 1, Sheet 1, Item 3) by
removing clamp (Figure 1, Sheet 1, Item 7).
10. Remove two hose clamps and disconnect hose (Figure 1, Sheet 1, Item 11) from elbow (Figure 1, Sheet 1,
Item 12) on right side of fuel tank (Figure 1, Sheet 1, Item 13) and from 90 degree male fitting (Figure 1,
Sheet 2, Item 14) at rear of fuel tank filler neck (Figure 1, Sheet 2, Item 15).
11. Remove 90 degree male fitting (Figure 1, Sheet 2, Item 14), elbow fitting (Figure 1, Sheet 2, Item 16), nipple
(Figure 1, Sheet 2, Item 17), seal nut (Figure 1, Sheet 2, Item 18), and washer (Figure 1, Sheet 2, Item 19).
12. Disconnect hose (Figure 1, Sheet 1, Item 20) from 90 degree bulkhead elbow (Figure 1, Sheet 1, Item 21) on
fuel fill pocket (Figure 1, Sheet 1, Item 22). If necessary, remove 90 degree elbow (Figure 1, Sheet 2,
Item 21).
13. Disconnect hose (Figure 1, Sheet 2, Item 20) from 90 degree elbow (Figure 1, Sheet 2, Item 23) on auxiliary
fuel pump (Figure 1, Sheet 2, Item 24).
0057-2
