TM 9-6115-730-24
0028
DISASSEMBLY - Continued
3. Remove eight nuts (Figure 1, Item 18), screws (Figure 1, Item 19), and two latches (Figure 1, Item 1).
4. Remove five foam damping sheets as required.
5. Remove nine locknuts (Figure 1, Item 6), screws (Figure 1, Item 7), and hinge (Figure 1, Item 8).
END OF TASK
ASSEMBLY
1. Install hinge (Figure 1, Item 8) and secure with nine screws (Figure 1, Item 7) and locknuts (Figure 1, Item 6).
2. If necessary, use old foam damping sheets as templates to cut new foam damping sheets.
3. Install five foam damping sheets.
4. Install two latches (Figure 1, Item 1), and secure with eight screws (Figure 1, Item 19) and nuts (Figure 1,
Item 18).
5. Install holding rod bracket (Figure 1, Item 17), door holding rod (Figure 1, Item 16), and door holding bracket
(Figure 1, Item 15), and secure with four screws (Figure 1, Item 14) and nuts (Figure 1, Item 13).
6. Install duct (Figure 1, Item 12) and secure with twelve washers (Figure 1, Item 11), lockwashers (Figure 1,
Item 10), and screws (Figure 1, Item 9).
END OF TASK
INSTALLATION
1. Install seal as required.
2. Install right rear door assembly (latch) (Figure 1, Item 2) and secure with nine lockwashers (Figure 1, Item 5),
washers (Figure 1, Item 4), and screws (Figure 1, Item 3).
3. Close right rear door assembly (latch) (Figure 1, Item 2) and secure by rotating and closing two latches
(Figure 1, Item 1).
END OF TASK
END OF WORK PACKAGE
0028-3/4 blank