TM 9-6115-730-24
0023
DISASSEMBLY - Continued
2. Remove door holding rod (Figure 1, Sheet 1, Item 11).
3. Remove 14 screws (Figure 1, Sheet 1, Item 12), washers (Figure 1, Sheet 1, Item 13), lockwashers (Figure 1,
Sheet 1, Item 14), and duct (Figure 1, Sheet 1, Item 15).
4. Remove eight nuts (Figure 1, Sheet 2, Item 16), screws (Figure 1, Sheet 2, Item 17), and storage box
(Figure 1, Sheet 2, Item 18).
5. Remove four screws (Figure 1, Sheet 2, Item 19), washers (Figure 1, Sheet 2, Item 20), lockwashers
(Figure 1, Sheet 2, Item 21), and baffle (Figure 1, Sheet 2, Item 22).
6. Remove six screws (Figure 1, Sheet 2, Item 23), washers (Figure 1, Sheet 2, Item 24), lockwashers (Figure 1,
Sheet 2, Item 25), and baffle (Figure 1, Sheet 2, Item 26).
7. Remove nine foam damping sheets as required.
8. Remove ten locknuts (Figure 1, Sheet 1, Item 6), screws (Figure 1, Sheet 1, Item 7), and hinge (Figure 1,
Sheet 1, Item 8).
END OF TASK
ASSEMBLY
1. Install hinge (Figure 1, Sheet 1, Item 8) and secure with ten screws (Figure 1, Sheet 1, Item 7), and locknuts
(Figure 1, Sheet 1, Item 6).
2. If necessary, use old foam damping sheets as templates to cut new foam damping sections.
3. Install nine foam damping sheets.
4. Install baffle (Figure 1, Sheet 2, Item 26) on duct (Figure 1, Sheet 1, Item 15) and secure with six lockwashers
(Figure 1, Sheet 2, Item 25), washers (Figure 1, Sheet 2, Item 24), and screws (Figure 1, Sheet 2, Item 23).
5. Install baffle (Figure 1, Sheet 2, Item 22) on duct (Figure 1, Sheet 1, Item 15) and secure with four
lockwashers (Figure 1, Sheet 2, Item 21), washers (Figure 1, Sheet 2, Item 20), and screws (Figure 1,
Sheet 2, Item 19).
6. Install storage box (Figure 1, Sheet 2, Item 18) on duct (Figure 1, Sheet 1, Item 15) and secure with eight
screws (Figure 1, Sheet 2, Item 17) and nuts (Figure 1, Sheet 2, Item 16).
7. Install duct (Figure 1, Sheet 1, Item 15) and secure with 14 lockwashers (Figure 1, Sheet 1, Item 14), washers
(Figure 1, Sheet 1, Item 13), and screws (Figure 1, Sheet 1, Item 12).
8. Install door holding rod (Figure 1, Sheet 1, Item 11).
9. Install two latches (Figure 1, Sheet 1, Item 1) and secure with eight screws (Figure 1, Sheet 1, Item 10) and
nuts (Figure 1, Sheet 1, Item 9).
END OF TASK
0023-4
