TM 9-6115-730-24
0021
DISASSEMBLY - Continued
2. Remove two wing nuts (Figure 1, Item 6) and two locknuts (Figure 1, Item 7) and two rod retainer latches
(Figure 1, Item 8).
3. Remove eleven screws (Figure 1, Item 9), lockwashers (Figure 1, Item 10), washers (Figure 1, Item 11), and
duct (Figure 1, Item 12).
4. Remove eight nuts (Figure 1, Item 13), screws (Figure 1, Item 14), and two latches (Figure 1, Item 1).
5. Remove four nuts (Figure 1, Item 15), screws (Figure 1, Item 16), holding rod bracket (Figure 1, Item 17),
door holding rod (Figure 1, Item 18), and door holding bracket (Figure 1, Item 19).
6. Remove eight locknuts (Figure 1, Item 20), screws (Figure 1, Item 22), washers (Figure 1, Item 21), and two
rod retainer brackets (Figure 1, Item 23).
7. Remove thirteen locknuts (Figure 1, Item 24), screws (Figure 1, Item 25), and hinge (Figure 1, Item 26).
END OF TASK
ASSEMBLY
1. Install hinge (Figure 1, Item 26) and secure with thirteen screws (Figure 1, Item 25) and locknuts (Figure 1,
Item 24).
2. Install two latches (Figure 1, Item 1) and secure with eight screws (Figure 1, Item 14) and nuts (Figure 1,
Item 13).
3. Install two rod retainer brackets (Figure 1, Item 23) and secure with eight screws (Figure 1, Item 22), washers
(Figure 1, Item 21), and locknuts (Figure 1, Item 20).
4. Install door holding bracket (Figure 1, Item 19), door holding rod (Figure 1, Item 18), holding rod bracket
(Figure 1, Item 17) and secure with four screws (Figure 1, Item 16) and nuts (Figure 1, Item 15).
5. Install duct (Figure 1, Item 12) and secure with eleven washers (Figure 1, Item 11), lockwashers (Figure 1,
Item 10), and screws (Figure 1, Item 9).
6. Install two rod retainer latches (Figure 1, Item 8) and secure with two locknuts (Figure 1, Item 7) and two wing
nuts (Figure 1, Item 6).
7. If necessary, use old foam damping sheets as templates to cut new foam damping sections.
8. Install six foam damping sheets.
END OF TASK
0021-3
