TM 9-6115-730-24
0009
TROUBLESHOOTING USING GSC FAULT CODES - Continued
SYMPTOM
40.
CID 360 E FMI 01
CID 360 E FMI 02
CID 360 E FMI 03
MALFUNCTION
Low Engine Oil Pressure Warning (Active & Logged).
FMI 01 - Data Is Valid But Data is Below Normal Operating Range.
FMI 02 - Erratic, Intermittent, or Incorrect Signal.
FMI 03 - Voltage Above Normal.
Event Code. Red LOW OIL PRESSURE indicator flashes when oil pressure drops below the
programmed low oil pressure setpoints. Engine shuts down and does not start until fault is corrected.
CORRECTIVE ACTION
STEP 1.
Set Battery Disconnect Switch to ON, Set DEAD CRANK SWITCH to NORMAL.
Turn the ENGINE CONTROL switch to COOL DOWN/STOP.
STEP 2.
Press ALARM CODES on GSC keypad.
STEP 3.
Check oil level and perform service per TM 9-6115-730-10.
STEP 4.
Verify the fault code has been cleared.
STEP 5.
Verify all alarm and fault codes.
a. If CID 100 is active, troubleshoot engine oil pressure sensor per SYMPTOM
15 and SYMPTOM 16.
b. Troubleshoot other alarm and fault codes, as necessary.
STEP 6.
Verify all programmable setpoints (WP 0083).
STEP 7.
Verify the fault code has been cleared.
0009-34
