TM 9-6115-729-24
0115
VALVE LASH ADJUSTMENT - Continued
4. Tighten nut (Figure 3, Item 17) on adjustment screw to 13-23 lb-ft (18-32 Nm).
5. Check adjustment and perform steps 1 thru 4 until inlet rocker arm (Figure 3, Item 11) is set to specification.
6. Perform steps 1 thru 5 on remaining two inlet rocker arms (Figure 3, Item 11).
7. Loosen nut (Figure 3, Item 17) and loosen adjustment screw (Figure 3, Item 18) on exhaust rocker arms
(Figure 3, Item 12) for cylinders 1, 3, and 5.
8. Refer to Table 3 and insert feeler gage of correct dimension between exhaust rocker arm (Figure 3, Item 12)
and exhaust valve stem (Figure 3, Item 21).
9. Turn adjustment screw clockwise (CW) until exhaust rocker arm (Figure 3, Item 12) is set to specification in
Table 3.
10. Tighten nut (Figure 3, Item 17) on adjustment screw (Figure 3, Item 18) to 13-23 lb-ft (18-32 Nm).
11. Check adjustment and perform steps 7 thru 10 until exhaust rocker arm (Figure 3, Item 12) is set to
specification.
12. Perform steps 7 thru 11 on remaining two exhaust rocker arms (Figure 3, Item 12).
13. Remove timing bolt (Figure 3, Item 20) from front of flywheel housing. Rotate flywheel 360 degrees
counterclockwise (CCW). Install timing bolt (Figure 3, Item 20) in front of flywheel housing.
NOTE
Perform steps 14 thru 17 if No. 1 cylinder is on exhaust stroke.
14. Loosen nut (Figure 3, Item 17) and loosen adjustment screw (Figure 3, Item 18) on inlet rocker arms (Figure
3, Item 11) for cylinders 3, 5, and 6.
15. Perform steps 1 thru 5 on three inlet rocker arms (Figure 3, Item 11).
16. Loosen nut (Figure 3, Item 17) and loosen adjustment screw (Figure 3, Item 18) on exhaust rocker arms
(Figure 3, Item 12) for cylinders 2, 4, and 6.
17. Perform steps 7 thru 11 on three exhaust rocker arms (Figure 3, Item 12).
18. Remove timing bolt (Figure 3, Item 20) and install plug (Figure 3, Item 19) on front of flywheel housing.
19. Install crankshaft damper and damper pulley (WP 0104).
20. Install manifold and valve cover (WP 0101).
END OF TASK
END OF WORK PACKAGE
0115-7/8 blank
