TM 9-6115-729-24
0076
INSTALLATION
1. If removed, install grease fitting (Figure 1, Item 14) on bracket (Figure 1, Item 13).
2. Install bracket (Figure 1, Item 13) and secure with four washers (Figure 1, Item 12) and bolts (Figure 1, Item
11).
3. Fill cavity of bearing (Figure 1, Item 9) with approximately 1 ounce (30 grams) of grease.
NOTE
Install bearing with lip seal facing away from engine.
4. Install retainer (Figure 1, Item 10), bearing (Figure 1, Item 9), O-ring (Figure 1, Item 8), and plate (Figure 1,
Item 7) on shaft (Figure 1, Item 5) and secure with two bolts (Figure 1, Item 6). Torque bolts (WP 0089).
5. Install shaft (Figure 1, Item 5) and attached parts on bracket (Figure 1, Item 13) and secure with three
washers (Figure 1, Item 4) and bolts (Figure 1, Item 3). Torque bolts (WP 0089).
6. Install fan pulley (Figure 1, Item 2) and secure with six bolts (Figure 1, Item 1). Torque bolts (WP 0089).
7. Install engine cooling fan and upper right fan guard (WP 0065).
8. Install engine cooling fan belt (WP 0072).
END OF TASK
END OF WORK PACKAGE
0076-3/4 blank
