TM 9-6115-729-24
0074
REMOVAL
1. Ensure generator set is fully stopped, ENGINE CONTROL switch is OFF/RESET, Battery Disconnect Switch is
OFF, and DEAD CRANK SWITCH is OFF before proceeding.
2. Open right front door, and right rear doors.
WARNING
Support starter when removing attaching hardware or starter may fall. Failure to comply can
cause injury to personnel and equipment damage.
3. Tag and disconnect wiring from ground terminal and solenoid on starter (Figure 1, Item 1).
4. Remove three bolts (Figure 1, Item 2), washers (Figure 1, Item 3), and starter (Figure 1, Item 1).
END OF TASK
INSTALLATION
WARNING
Support starter when removing attaching hardware or starter may fall. Failure to comply can
cause injury to personnel and equipment damage.
1. Position starter (Figure 1, Item 1) into flywheel housing, ensure starter gear teeth mesh with flywheel gear
teeth, and line up mounting holes. Install three washers (Figure 1, Item 3) and bolts (Figure 1, Item 2).
Tighten bolts.
2. Clean electrical contacts if necessary.
3. Remove tags. Connect wiring to solenoid on starter (Figure 1, Item 1) and wiring to ground terminal.
4. Close right front door and right rear doors.
0074-2
