TM 9-6115-729-24
0017
INSPECTION INSTRUCTIONS - Continued
Castings, Forgings, and Machined Metal Parts
1. Inspect machined surfaces for nicks, burrs, raised metal, wear, or other damage.
2. Check all inner and outer surfaces for breaks or cracks.
3. Mark all damaged material for repair or replacement.
TAGGING INSTRUCTIONS
When tagging is required during the removal procedure, remove tags during the installation procedure.
REPAIR INSTRUCTIONS
NOTE
Refer to Source, Maintenance, and Recoverability (SMR) Codes assigned to support items listed in the
RPSTL (see TM 9-6115-729-24P).
Any repair procedure peculiar to a specific part or component is covered in the work package relating to that item.
After repair, clean all parts thoroughly to prevent dirt, metal chips, or other foreign material from entering working
parts.
Castings, Forgings, and Machined Metal Parts
1. Minor cracked castings or forgings may possibly be repaired. Refer to TC 9-237.
2. Repair minor damage to machined surfaces with a fine mill file or crocus cloth dipped in breakthrough
cleaning solvent.
3. Machined surfaces which are deeply nicked could affect the assembly operation and should be replaced.
4. Minor damage to threaded capscrew holes should be repaired with thread tap of same size to prevent cutting
oversize.
END OF WORK PACKAGE
0017-3/4 blank
