TM 9-6115-729-10
100 kW TACTICAL QUIET GENERATOR SET
0006 00
OPERATION UNDER USUAL CONDITIONS Continued
ASSEMBLY AND PREPARATION FOR USE Continued
Installation of Ground Rod Continued
5.
Insert ground cable (2) through slot on output load terminal board terminal marked GND (9).
6.
Tighten nut on GND terminal (9) with wrench (7).
7.
Connect coupler (5) to ground rod (1) and screw driving stud (4) into coupler (5). Make sure that driving stud is
screwed completely into coupler and contacts top of ground rod.
8.
Drive ground rod into ground until coupler is just above surface.
9.
Remove driving stud and install another section of ground rod into coupler.
10. Repeat steps 7, 8, and 9 until ground rod has been driven 8 feet or deeper. Drive ground rod down until last coupler is
just above ground surface.
11. Remove coupler (5) and driving stud (4) and return to storage inside front battery compartment door.
0006 00-3
