ARMY TM 9-6115-670-14&P
6-64
6.25. BEARING CASE COVER.
This task covers: Replace
INITIAL SETUP
Tools
General Mechanic's Tool Kit
(Item 1, Appendix B)
Equipment Conditions
Flywheel removed (para 5.38).
Materials/Parts
Sealing Compound
(Item 18, Appendix B)
Bearing Case Cover
Bearing Case Cover Gasket
(Item 1, Appendix J)
REPLACE
a. Remove ten bolts (1, Figure 6-22) and remove bell housing (2).
b. Remove sixteen bolts (3) securing bearing case cover (4) to engine (6).
c. Install two of the bolts (3) removed in step b into two bolt holes (7) on either side of cover (4).
d. Remove cover (4) by pulling on two bolts (3).
e. Remove two bolts (3) from cover (4).
f. Remove gasket (5) from cover.
g. Apply sealing compound to both sides of new gasket (5) and install new gasket (5) on cover
(4).
h. Install cover (4) and secure with sixteen bolts (3). Torque bolts between 7.23 and 8.32 ft-lbs
(9.81 to 11.28 Nm).
i. Install bell housing (2) and secure with 10 bolts (1).
NOTE
Ensure that the up-arrow casting mark on bearing case
cover is pointing up.
