TM 9-6115-664-13&P
1. START / PRIME - RUN / OFF Switch
4. REMOTE / LOCAL Switch
2. PREHEAT OIL / AIR Switch
5. REMOTE Control Panel Electrical Connector
3. APU ON Switch
Figure 2-2. Operation Using Local Control Panel
(4)
Momentarily move the APU ON switch (3) to the ON position, then release. The APU ON switch activates the
alternator and applies the load.
b. Operating the APU Using Remote Control Panel.
NOTE
If ambient temperature is below 32° F (0º C), refer to paragraph 2-10, Operation in
Unusual Weather, for operating instructions.
(1)
Connect the remote control panel electrical cable to the REMOTE electrical connector (5, Figure 2-2) on the
local control panel.
(2)
Place the REMOTE / LOCAL switch (4) in the REMOTE position.
(3)
Conduct remote control panel self test by pushing the PRESS TO TEST LAMPS push button (5, Figure 2-3).
All LED indicator lights (3, 4, 7, 9) shall illuminate. If an indicator light fails to illuminate, refer trouble to next
higher level of maintenance.
(4)
Place the START / PRIME RUN / OFF switch (11) in the PRIME RUN position.
2-18
