TM 9-6115-664-13&P
4-45. ENGINE START SOLENOID / MANUAL START SWITCH MAINTENANCE
This task covers removal, inspection, installation, and adjustment
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
APU Shut Down
and Repair (Item 1, App. B)
NATO Plug Disconnected
Parts/Materials:
Adhesive, Loctite (Item 1, App. E)
A.
REMOVAL.
WARNING
Make sure that electrical cable is
disconnected from NATO receptacle
before performing any maintenance
action. Failure to do so can result in
electrical shock.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Open top front cover on APU enclosure by turning
latches.
2.
Disconnect solenoid electrical connector (1, Figure
4-35).
3.
Open oil filter access door. Depress top of solenoid
(2). Disengage and remove clip (3) to release
solenoid from engine throttle control.
4.
Remove solenoid (2) from mounting bracket (4) by
removing two screws (5), lockwashers (6), and nuts
(7).
5.
Tag and disconnect manual start switch electrical
connector (8).
Figure 4-35. Solenoid and Start Switch
4-108
