TM 9-6115-653-14&P
CHAPTER 5
DIRECT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I. INTRODUCTION
5-1 General. This chapter contains direct and general support level maintenance procedures for components of the
M200A1 trailer added when the trailer is used as part of the PU-732/M power unit These components are not covered in
the overall trailer maintenance manual For all other direct and general support maintenance procedures on the trailer,
refer to TM 9-2330-205-14&P For direct and general support maintenance procedures on the generator set, refer to
TM 5-6115-464-34
WARNING
Before performing any maintenance that requires climbing on or under trailer, set trailer
handbrakes, chock wheels and lower rear leveling Jacks Injury to personnel could result from
trailer suddenly roiling or tipping
Section II. MAINTENANCE OF POWER UNIT TRAILER
5-2 Step and Fender Repair. Repair of the front and rear steps and the fenders is limited to straightening,
welding
and repainting If required, repaint in accordance with MIL-T-704, Type F. Color Green, No 383 of MIL-C-46168 If power
unit is painted in camouflage, refer to paragraph 5-4, Marking
5-3 Accessory Box Repair. (See figure 5-1 ) The accessory box is repaired by replacing the latch and strike
assemblies The box itself may be straightened, welded and repainted If required, repaint in accordance with MiL-T-704,
Type F. Color Green, No 383 of MIL-C-46168 If power unit is painted in camouflage, refer to paragraph 5-4, Marking
Replace latch and strike assemblies as follows
a.
Grind off or drill out solid rivets (1, figure 5-1 ) securing latch and strike assembly (2) to accessory box (3)
b.
Position new latch and strike assembly (2) on accessory box (3) and secure with solid rivets (1)
c.
Touch up with paint as required
4885 036
Figure 5-1. Accessory Box Repair.
5-1
