ARMY TM 9-6115-645-24
AIR FORCE TO 35C2-3-444-12
MARlNE CORPS TM 09244A/09245A-24/2
2-80
2–80.1
COOLAN T OVERFLOW AND DRAIN HOSES.
Removal.
a.
Shut down generator set.
b. Open battery access door and disconnect negative battery cable.
c.
Open engine access doors.
d. Locate overflow or drain hose to be removed, as shown on FIGURE 2-23 and FIGURE 2–25.
e.
Disconnect hose at both ends and remove from generator set.
2-80.2 Inspection.
a.
Shut down generator set.
b. Open engine access doors.
c.
Inspect hoses for cracks, holes, and rotting.
d. Close engine access doors.
2–80.3 Installation.
a.
Install overflow or drain hose in generator set as removed.
b. Close engine access doors.
c.
Connect negative battery cable and close battery access door.
2-81
RADIATOR.
2-81.1 Removal.
a.
Shut down generator set.
b. Open engine access doors.
c.
Remove generator set top housing section, paragraph 2-16.1.
d. Remove bolts (14, FIGURE 2-23), washers (15), Iockwashers (1 6), and fan guard (17) from shroud (21).
WARNING
Coolant can get very hot. Allow system to cool down before performing main-
tenance. Failure to follow these instructions could result in severe burns and in-
juries.
Always remove radiator cap slowly to permit pressure to escape. Failure to follow
this warning could result in severe injury.
e.
Slowly remove radiator cap (1).
f.
Open radiator drain valve (36) and drain coolant/antifreeze into suitable container.
g.
Remove radiator filler hose assembly, paragraph 2-77.1,
h. Remove upper coolant hose, paragraph 2-78.1.
i.
Remove lower coolant hose, paragraph 2-79.1.
Remove bolts (18), Iockwashers (1 9), and flatwashers (20) and allow shroud (21) to rest on fan.
k. Remove nuts (22), Iockwashers (23), bolts (24), and washers (25) securing support rods (26) to bracket on
engine.
2-113
