ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3445-12
MARINE CORPS TM 09249A/09246A-24/2
j.
Remove fuel pickup, paragraph 2-92-1.
k.
Remove fittings (7) and (8) from excess fuel studs (10) on right side of tank
I.
Remove fitting (9) from excess fuel stud (10) on left side of tank.
m.
Remove studs (10), washers (11), and bushings (12) from fuel tank.
n.
Cover all openings.
4-7-3
Installation.
a.
Remove covers placed over openings.
b.
Install bushings (12, FIGURE 4-4), washers (11), and studs (10) in fuel tank (6).
C.
Install fitting (9) in excess fuel stud (10) on left side of fuel tank.
d.
Install fittings (7), and (8), in excess fuel studs (10) on right side of fuel tank.
e.
Install low fuel level/ auxiliary fuel pump float switch, paragraph 2-91-4.
f.
Install fuel level sender, paragraph 2-90-4.
g.
Install fuel pickup, paragraph 2-92-3.
h.
Install fuel tank (6) in skid and secure with plates (5), bolts (4), washers (3), lockwashers (2), and nuts (1).
i.
Install engine and generator assembly, paragraph 3-6-2.
j.
Install fuel tank drain valve, paragraph 2-89-2.
k.
Service fuel tank. Refer to TABLE 2-2 for proper fuel.
I.
Connect negative battery cable. Close battery access door.
Section IV. MAINTENANCE OF OUTPUT BOX ASSEMBLY
4-8
OUTPUT BOX ASSEMBLY
4-8-1 Removal.
a.
Shut down generator set.
b.
Open battery access door and disconnect negative battery cable.
C.
Remove control box assembly, paragraph 2-19-2.
d.
Remove top housing section, paragraph 2-16-1.
e.
Remove air cleaner assembly, paragraph 2-73-3.
f.
Remove output box access door, paragraph 2-14-1
g.
Remove rear housing panel, paragraph 2-18-1.
4-15
