ARMY TM 9-6115-644-24
AIR FORCE TO 35C2-3-446-12
MARINE CORPS TM 09249A/09246A-24/2
i.
j
k.
I.
m.
n.
o.
p.
q.
r.
s.
3-6-2
Installation.
a.
Install engine shock mounts (14, FIGURE 3-1) on skid base with bolts (13) washers (12), and
nuts (11).
b.
C.
d.
e.
f.
g.
Remove nuts (1, FIGURE 3-1) washers (2), snubbing washers (3), washers (37), and bolts (4) from
engine mounts (5).
Remove rear fork lift guide from generator set, paragraph 4-25-1.
Remove nuts (6), washers (7), bolts (8), snubbing washers (9) and Belleville washers (10) from
generator mounts.
Tie wrap generator power leads and secure out of the way.
CAUTION
Rated capacity of overhead hoist should be at least 2000 Ibs (907 kg). Arrange lifting
device so that it supports both engine and generator to avoid undue stress on the
engine and generator coupling.
Attach lifting harness to engine and generator lifting points. Raise engine and generator assembly
from skid base.
Move engine and generator assembly to maintenance work area. Support assembly on maintenance
stand or fixture.
Remove engine shock mounts (14) from skid base by removing nuts (11), washers (12) and
bolts (13).
Remove shock mounts (15) from generator mounting points on skid base.
Remove engine mounting brackets (5) by removing bolts (16), lockwashers (17,) and washers (18).
Remove engine support brackets (22) by removing bolts (19), lockwashers (20), and washers (21).
Remove generator mount angles (29), plates (28), nuts (23) and (27), washers (24) and (26) and
bolts (25) from generator.
Position generator shock mounts (15) in skid base.
Install engine mounting brackets (5) on engine with bolts (16), lockwashers (17), and washers (18).
Torque bolts (16) to 120 ft-lbs (162.6 Nm).
Install engine support brackets (22) on engine with bolts (19), lockwashers (20), and washers (21).
Install generator mount angles (29) and plates (28) on generator with bolts (25), washers (24) and
(26), and nuts (23) and (27).
CAUTION
Rated capacity of overhead hoist should be at least 2,000 Ibs (907 kg). Arrange lifting
device so that it supports both engine and generator to avoid undue stress on the
engine and generator coupling.
Attach lifting harness to engine and generator lifting points. Raise engine and generator assembly
from maintenance stand or fixture.
Position engine and generator assembly on skid base aligning mounting holes and brackets
Change 1 3-11
