ARMY TM 9-6115-643-24
AIR FORCE TO 35C2-3-445-22
c. Remove generator set housing rear panel, paragraph 2.18.1.
d. Remove generator assembly from generator set, paragraph 4.16.1.
e. Remove generator end bell, paragraph 4.18.1.
f. Remove main rotor assembly, paragraph 4.22.2.
g. Remove main stator, paragraph 4.23.2.
h. Remove setscrews(13, FIGURE 4-10) from generator housing (31).
WARNING
Hot metal surfaces can cause burns to skin. Wear protective gloves and
eye protection when applying heat to the generator housing. Failure to
observe this warning could result in severe personal injury.
C A U T I ON
Ensure wires are not touching generator housing and are away from
open flame when heat is applied. Be sure to distribute heat evenly to
prevent damage to the housing.
i. Apply heat evenly to ribs of generator housing (31) at end bell section using an acetylene torch with a rose bud
tip, refer to FIGURE 4-11 for location of ribs. Heat ribs until exciter stator (14) drops down and lift off housing (31).
4.20.3 Installation.
a. Stand generator housing (31, FIGURE 4-10) on end with end bell opening in a downward position.
b. Position exciter stator (14) in generator housing (31). Ensure exciter stator wires are pointing upward and are in
alignment with wiring port on side of generator housing (31).
W A R N I NG
Hot metal surfaces can cause burns to skin. Wear protective gloves and
eye protection when applying heat to generator housing. Failure to ob-
serve this warning could result in severe personal injury.
CAUTION
Ensure wires are not touching generator housing and are away from
open flame when heat is applied. Be sure to distribute heat evenly to
prevent damage to housing.
c. Apply heat evenly to ribs of generator housing (31) at end bell section using an acetylene torch with a rose bud
tip, refer to FIGURE 4-11 for rib locations. Heat ribs until exciter stator (14) drops into position.
d. Install setscrews (13) in generator housing (31).
4-37