ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
2-93-4. Installation.
a.
Install coolant high temperature switch (5, Figure 2-25) Into thermostat housing.
b. Install electrical leads and remove tags.
c.
Connect negative battery cable and close access door.
2-94-1.
a.
b.
c.
d.
2-94-2.
a.
b.
c.
d.
2-94-3.
a.
b.
c.
d.
Shut down generator set.
Open both engine access doors and disconnect negative battery cable.
NOTE
Magnetic pickup is located on right side of flywheel housing.
Tag and disconnect electrical leads to magnetic pickup (7, Figure 2-25).
Loosen nut (6) and unscrew magnetic pickup (7) from flywheel housing.
Cleaning and Inspection.
Remove magnetic pickup, paragraph 2-94-1.
Use clean, low pressure air, 30 psI maximum. Wear protective glasses when using
compressed air. Failure to follow these instructions could result in eye injury.
Dry cleaning solvent Is flammable and toxic to eyes, skin, and respiratory tract.
Skin/eye protection required. Avoid repeated/prolonged contact. Good general
ventilation Is normally adequate.
Ciean magnetic pickup with filtered compressed air and cleaning cloth (Item 6, Appendix C) lightly moistened
with dry cleaning solvent (Item 18, Appendix C).
Inspect magnetic pickup for cracked casing, corrosion, stripped or damaged threads, and bent or broken
connector pins.
Install magnetic pickup, paragraph 2-94-3.
Screw magnetic pickup (7, Figure 2-25) into flywheel housing until pickup bottoms out on flywheel.
Back magnetic pickup out 1-1/2 turns and finger tighten nut (6).
Connect electrical connectors and remove tags.
Adjust magnetic pickup (7) in accordance with paragraph 2-94-4.
2-130
2-94. MAGNETIC PICKUP.
Removal.
Installation.
