ARMY TM 9-6115-641-24
AIR FORCE TO 35C2-3-456-12
Section XI.
2-58.
OUTPUT BOX ASSEMBLY.
2-56-1.
a.
b.
c.
d.
2-56-2.
a.
b.
c.
Inspection.
Shut down generator set.
MAINTENANCE OF OUTPUT BOX ASSEMBLY
Remove control box top panel, paragraph 2-16-1.
Inspect output box panels and tray for cracks, dents, loose paint, and corrosion.
Install control box top panel, paragraph 2-16-4.
Repair.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC
paint dust is a health hazard and could cause personaI injury if warning is not
followed.
Repair all dents and cracks, and remove all loose paint.
Remove light corrosion with fine abrasive paper (Item 15, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
2-59. OUTPUT BOX/ENGINE HARNESS.
2-59-1. Inspection.
a.
Shut down generator set.
b. Remove control box top panel, paragraph 2-16-1.
c.
Open engine access doors.
d.
Inspect wiring harness (1, Figure 2-16) for burned, bent, corroded, and broken terminals.
e.
Inspect connectors for cracks, corrosion, stripped threads, bent or broken pins, and obvious damage.
f.
Inspect wire insulation for burns, deterioration, and chafing.
g.
Install control box top panel, paragraph 2-16-4.
h.
Close engine access doors.
2-59-2. Repair.
a.
Replace damaged or broken terminals.
b. Replace damaged or broken connector pins.
2-60. CURRENT TRANSFORMER.
2-60-1. Inspection.
a.
Shut down generator set.
b. Remove control box top panel, paragraph 2-16-1.
c.
Inspect current transformer (2, Figure 2-16) for cracks, loose or stripped threads, and evidence of
overheating.
d. Install control box top panel, paragraph 2-16-4.
2-90
