TM 5-6115-630-14&P
h.
j .
Remove locking pin from leg prop assembly on rear of trailer. Swing leg prop back and up into traveling
position and secure with pin.
i. Attach power unit to towing vehicle. (Refer to TM 9-2330-202-14&P.)
Release trailer handbrakes.
4-4. Reinstallation After Movement. After movement to a new worksite, install power unit in accordance
with paragraph 4-2.
Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT AND
DIAGNOSTIC EQUIPMENT (TMDE)
4-5. Tools and Equipment. There are no special tools or equipment required to maintain the PU-751/M
power unit.
4-6. Maintenance Repair Parts. Repair parts and equipment for maintenance of this power unit are listed
and illustrated in the repair parts and special tools list in Appendix D of this manual.
Section IV. LUBRICATION INSTRUCTIONS
4-7. General. Detailed instructions for the lubrication of the major components of the power unit are contained
in the applicable Lubrication Orders (LO’s). Refer to DA Pam 25-30 to ensure that the latest editions of the L.O.’S
are used. This section contains lubrication instructions that are not included in the Lubrication Orders.
4-8.
4-9.
a.
b.
General Lubrication. Refer to TM 5-6115-584-12 for generator set Lubrication Order.
Trailer Assembly Lubrication.
Trailer Assembly Lubrication. Refer to TM 9-2330-202-14&P for trailer Lubrication Order.
Leg Prop Assembly Lubrication. The rear leg prop assembly is a modification to the standard M116A1
trailer and, as such, does not appear in the associated LO. Semiannually lubricate leg prop assembly as follows:
WARNING
Clean parts in a well-ventilated area. Avoid inhalation of solvent fumes and prolonged
exposure of skin to cleaning solvent. Wash exposed skin thoroughly. Dry cleaning
solvent (PD-680) used to clean parts is potentially dangerous to personnel and property.
Do not use near open flame or excessive heat. Flash point of solvent is 100°F to 138°F
(38°C to 59°C).
Clean hydraulic lubrication fitting and area around lubrication points with PD-680 or equivalent.
Inject sufficient GAA grease into hydraulic fitting to lubricate screw threads inside leg prop assembly
( 1)
(2)
4-7
