TM 5-6115-625-14&P
a. Removal.
(1) Remove four screws (1, figure 4-7), four flat washers (2), and four nuts (3) securing
bracket (4) to step (5).
(2) Remove bracket (4) from step (5).
b. Installation.
(1) Position fire extinguisher bracket (4) on step (5).
(2) Insert four screws (1) down through bracket (4) and through step (5).
(3) Install one washer (2) and one nut (3) on each screw (1). Tighten hardware to secure
bracket (4).
4-20.
Front Steps Replacement. (See figure 4-8.) The roadside and curbside front steps are
symmetrical, and replacement procedures are the same except where noted in the steps below.
a. Removal.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
N O TE
When removing roadside front step, omit steps (1) and (2).
Remove fuel can brackets (paragraph 4-17, a).
Remove accessory box (paragraph 4-18, a).
Remove cotter pin (1, figure 4-8) and clevis pin (2) securing handbrake cable (3) to
handbrake lever mechanism (4).
Remove two screws (5), two flat washers (6) and two nuts (7) securing handbrake bracket
(8) to trailer frame (9).
Remove two screws (10), two flat washers (11) and two nuts (12) securing handbrake
cable bracket (13) to front step (14).
N O TE
There are two screws, flat washers, and nuts securing handbrake bracket to
front step. It is only necessary to remove one set of attaching hardware to
remove front step from trailer frame.
Remove screw (15), flat washer (16), Iockwasher (17) and nut (18) directly beneath
pivot point of handbrake lever (4).
Remove seven screws (19), 14 flat washers (20) and seven nuts (21) securing front step
(14) to front edge of fender (22).
Remove four screws (23, 24 and 25), eight flat washers (26) and four nuts (27) securing
front step (14) to edge of trailer frame (9).
4 - 1 6
