TM11-6125-256-34
(1) Tag and disconnect leads to current relay
(2) Carefully remove retainer spring clip (8) and
compression spring (9)
assembly SW1 (92)
(3) Remove nuts (5) lock washers (6) nuts (7) and
(2) Remove self locking nuts (95) washers (94)
movable contact assembly (items 10 11 and 12) Do not
screw (93), and current relay assembly (92)
disassemble parts
(4) Remove insulator (13) spring (15) and plunger
(3) Disassemble the control box assembly only to
the extent necessary to make repairs Tag all leads before
(14)
removing parts
(5) Remove screws (25) lock washer (26) washers
(27) and stationary contacts (28)
d Current Relay Assembly (fig 4-7)
NOTE
(6) Remove nuts (16) lock washer (17) and washers
(18)
The current relay assembly is a subassembly of
the control box Refer to paragraphs 4-11
through 4-13 for control box assembly repair
procedures
(7) Remove screws (19) lock washers (20) washers
(21) and relay base (32) with parts attached from
magnet case and bracket assembly (40) Do not remove
(1) Remove nuts (1) lock washers (2) washers (3)
parts from relay base unless replacement is necessary
and contact cover (4)
LEGEND FOR FIGURE 4-7
4-25
