TM 11-6125-240-34P
SECTION I
INTRODUCTION
1. Scope
Definition
Code
This manual lists spares and repair parts; special
PA Item procured and stocked for anticipated or
tools; special test, measurement, and diagnostic
known usage.
equipment (TMDE), and other special support
XDA support item that is not stocked. When
equipment required for performance of direct sup-
required, item will be procured through nor-
port and general support maintenance of the
mal supply channels.
PU-545/A. It authorizes the requisitioning and
NOTE
issue of spares and repair parts as indicated by the
Cannibalization or salvage may be used
source and maintenance codes.
as a source of supply for any items source
coded above except those coded XA and
2. General
aircraft support items as restricted by
This Repair Parts and Special Tools List is divided
AR 700-42.
into the following sections:
(2) Maintenance code. Maintenance codes are
assigned to indicate the levels of maintenance
and repair parts authorized for use in the perfor-
authorized to USE and REPAIR support items. The
mance of maintenance. The list also includes parts
maintenance codes are entered in the third and
which must be removed for replacement of the
fourth positions of the Uniform SMR Code format
authorized parts. Parts lists are composed of func-
as follows:
tional groups in numeric sequence, with the parts in
(a) The maintenance code entered in the third
e a c h group listed in figure item number se
position will indicate the lowest maintenance level
quence.
authorized to remove, replace, and use the support
b. Section III. Special Tools List. Not applicable.
item. The maintenance code entered in the third
c. Section IV. National Stock Number and Part
position will indicate one of the following levels of
Number Index. A list, in National item iden-
maintenance:
tification number (NIIN) sequence, of all National
Application/Explanation
Code
stock numbers (NSN) appearing in the listings,
FSupport item is removed, replaced, used at the
followed by a list, in alphameric sequence, of all part
direct support level.
numbers appearing in the listings. National stock
HSupport item is removed, replaced, used at the
numbers and part numbers are cross-referenced to
general support level.
each illustration figure and item number ap-
(b) The maintenance code entered in the
pearance.
fourth position indicates whether the item is to be
repaired and identifies the lowest maintenance level
3. Explanation of Columns
with the capability to perform complete repair (i.e.,
c. Illustration. This column is divided as follows:
all authorized maintenance functions). This position
(1) Figure number. Indicates the figure number
will contain one of the following maintenance codes:
of the illustration on which the item is shown.
Code
Application/Explanation
(2) Item number. The number used to identify
H The lowest maintenance level capable of com-
item called out in the illustration.
plete repair of the support item is the general
b. Source, Maintenance, and Recoverability
support level.
(SMR) Codes.
ZNonreparable. No repair is authorized.
(1) Source Code. Source codes indicate the man-
(3) Recoverability code. Recoverability codes
ner of acquiring support items for maintenance,
are assigned to support items to indicate the
repair, or overhaul of end items. Source codes are en-
disposition action on unserviceable items. The
tered in the first and second positions of the
recoverability code is entered in the fifth position of
Uniform SMR Code format as follows:
the Uniform SMR Code format as follows:
1
