TM 11-6115-21 8-24P
SECTION I
INTRODUCTION
1. Scope
Code
Definition
PA Item procured and stocked for anticipated or
This manual lists spares and repair parts; special tools;
known usage.
special test, measurement, and diagnostic equipment
XD A support item that is not stocked. When
(TMDE), and other special support equipment required
required, item will be procured through normal
for performance of organizational, direct support, and
supply channels.
general support maintenance of the G-43/G and G-
NOTE
77/G. It authorizes the requisitioning and issue of
Cannibalization or salvage may be used as a
spares and repair parts as indicated by the source and
source of supply for any items source coded
maintenance codes.
above except those coded XA and aircraft
support items as restricted by AR 700-42.
2. General
(2) Maintenance code. Maintenance codes
This Repair Parts and Special Tools List is divided into
are assigned to indicate the levels of maintenance
the following sections:
authorized to USE and REPAIR support items. The
a. Sections II and V. Repair Parts List. A list of
maintenance codes are entered in the third and fourth
spares and repair parts authorized for use in the
positions of the Uniform SMR Code format as follows:
performance of maintenance. The list also includes
(a) The maintenance code entered in
parts which must be removed for replacement of the
the third position will indicate the lowest maintenance
authorized parts. Parts lists are composed of functional
level authorized to remove, replace, and use the support
groups in numeric sequence, with the parts in each
item. The maintenance code entered in the third
group listed in figure and item number sequence.
position will indicate one of the following levels of
b. Sections III and VI. Special Tools List. Not
maintenance:
applicable.
Code
Application/Explanation
c. Sections IV and VII. National Stock Number
F
Support item is removed, replaced, used at the
and Part Number Index. A list, in National item
direct support level.
identification number (NIIN) sequence, of all National
H Support item is removed, replaced, used at the
stock numbers (NSN) appearing in the listings,
general support level.
followed by a list, in alphanumeric sequence, of all part
(b) The maintenance code entered in
numbers appearing in the listings. National stock
the fourth position indicates whether the item is to be
numbers and part numbers are cross-referenced to each
repaired and identifies the lowest maintenance level
illustration figure and item number appearance.
with the capability to perform complete repair (i.e., all
authorized maintenance functions). This position will
3. Explanation of Columns
contain one of the following maintenance codes:
a. Illustration.
This column is divided as
Code
Application/Explanation
follows:
F
The lowest maintenance level capable of
(1) Figure number. Indicates the figure
complete repair of the support item is the direct
number of the illustration on which the item is shown.
support level.
(2) Item number. The number used to
H The lowest maintenance level capable of
identify item called out in the illustration.
complete repair of the support item is the general
b. Source, Maintenance, and Recoverability
support level.
(SMR) Codes.
Z Non-reparable. No repair is authorized.
(1) Source code. Source codes indicate the
(3) Recoverability code.
Recoverability
manner of acquiring support items for maintenance,
codes are assigned to support items to indicate the
repair, or overhaul of end items. Source codes are
disposition action on unserviceable items. The
entered in the first and second positions of the Uniform
recoverability code is entered in the fifth position of the
SMR Code format as follows:
Uniform SMR Code format as follows:
1
