ARMY TM 9-6116-644-24
AIR FORCE TO 35C2-446-12
MARINE CORPS TM 09249A/09246A-24/2
Install control box top panel, paragraph 2-15-4.
d. Connect negative battery cable. Close battery access door.
2-67 CONTROL PANEL.
Shut down generator set.
Open battery access door and disconnect negative battery cable.
Remove press to test Iights from control panel (do not unsolder wires), paragraph 2-21-3.
Remove VOLTAGE adjust potentiometer from control panel (do not remove wires), paragraph 2-34-2.
Remove FREQUENCY adjust potentiometer from control panel (do not remove wires), paragraph 2-35-2.
Tag and disconnect all electrical Ieads to remaining indicators and switches on control panel (10, FIGURE 2-19).
Remove screw (1), nut (2), and strap (3).
Remove bolts (4) and (6), nuts (5) and (7), bracket (9), clamp (8), and control panel (10) from control box assem-
Remove bolts (11), nuts (12), and hinge (13) from control box assembly.
Inspect control panel (10, FIGURE 2-19) for dents, cracks, loose paint, and corrosion.
Wear a protective mask and gloves when sanding CARC painted surfaces. CARC paint
dust is a health hazard and could cause personal injury if warning is not followed.
Repair all dents, cracks, and remove all loose paint.
Remove light corrosion with fine grit abrasive paper (Item 16, Appendix C).
Repaint surface in accordance with TM 43-0139. (F) Refer to applicable directives.
Install hinge (13, FIGURE 2-19) on control box assembly with bolts (11) and nuts (12).
Install control panel (10), clamp (8), and bracket (9) on control box assembly with bolts (4) and (6), and nuts (5)
Install strap (3) on control panel (10) with screw (1) and nut (2).
Connect all electrical wires to indicators and switches as tagged. Remove tags.
Install press to test lights, paragraph 2-21-4.
Install VOLTAGE adjust potentiometer, paragraph 2-34-4.
Install FREQUENCY adjust potentiometer, paragraph 2-35-4.