TM 9-6150-228-13&P
5.9
INTERIOR PANEL BOARD ASSEMBLY.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic's Automotive Tool Kit
Reference
(Item 2, Appendix B).
Para 4.14 Sub panel removed.
Para 4.16 Circuit breakers (60 and 100 amp)
removed.
Para 5.8 Circuit breakers (400 amp) removed.
Materials/Parts
General Safety Instructions
Rivets, Plastic (Appendix F).
Edge Trim, Plastic (Appendix F).
WARNING
Personnel Required
High voltage is present in this equipment during
operation. Do not attempt making any repairs
One.
without first shutting down all input power from the
power distribution panel. Failure to observe this
warning could result in serious injury or death.
REMOVAL
a. Sub Chassis and Bus Bar Connectors.
(1) Remove eighteen screws (1 and 3, Figure 5-4), eighteen sub chassis connectors (2 and 4) and nine isolator
blocks (5).
(2) Remove eighteen screws (6) and nine mounting brackets (7).
(3) Tag and identify two cables (1, Figure 5-5). Loosen two set screws (2) and remove cables (1) from
connectors.
(4) Tag and remove leads from neutral bus bar (4).
(5) Remove two screws (3) and one neutral bus bar (4).
(6) Remove four screws (5) and neutral bus bar bracket (6) from Z-rail (25).
(7) Remove four screws (7) and two bus bar connectors (8).
(8) Remove two plastic rivets (9) and two breaker insulations (10). Discard plastic rivets.
5-8
