TM 9-6150-226-13
Table 5-3.
CRIMP TOOLS (REFER TO PARA 5-9C) (cont)
Item No.
Nomenclature
Size
Part Numbers
11g
Locator, pin/
6
4297-6
socket
M22520/23-10
11h
Crimping die,
6
414DA-6N
pin/socket
M22520/23-03
(2) 100-Amp, 8-Wire Cables.
(a) Carefully cut and remove 3-1/2 inches (89 mm) of outer
cable jacket from end of cable.
(b) Carefully cut and remove 7/8 inch (22 mm) of conductor
insulation from end of each conductor.
(c) Attach electrical connector to cable end.
(3) 40/60-Amp, 5-Wire Cables.
(a) Carefully cut and remove 3-1/2 inches (89 mm) of outer
cable jacket from end of cable.
(b) Cut off 1/2 inch (13 mm) from phases A, B, C, and neutral
conductor (the four large conductors).
(c) Carefully cut and remove 7/8 inch (22 mm) of conductor
insulation from end of each conductor.
(d) Attach electrical connector to cable end.
(4) 60-Amp, 4-Wire Cables.
(a) Carefully cut and remove 3 inches (76 mm) of outer cable
jacket from end of cable.
(b) Carefully cut and remove 7/8 inch (22 mm) of conductor
insulation from end of each conductor.
(c) Attach electrical connector to cable end.
(5) 20-Amp, 3-Wire Cables.
(a) Carefully cut and remove 1/2 inch (13 mm) of outer cable
jacket from end of cable.
(b) Carefully cut and remove 3/8 inch (10 mm) of conductor
insulation from end of each conductor.
(c) Attach electrical connector to cable end.
5-13
