TM 9-6115-729-24
0012
USING ELECTRONIC TECHNICIAN (ET) SOFTWARE - Continued
STEP 7.
Select Logged Diagnostic Codes by clicking on the Logged Diagnostic Codes icon or click on the
pull down menu for Diagnostics and selecting Logged Diag. Codes.
a. The codes listed in the Logged Diagnostics Code list are shown with the top priority code from the
top down. The first code shown is the most important and must be corrected first. These codes
are the same as the Active Diagnostic Codes except they are logged over time.
b. To CLEAR any or all of the Logged Diagnostic Codes, click on a Logged Diagnostic Code in the
list to highlight it. Click on the CLEAR button in the lower left corner of the page.
(1)
A pop up window appears with the message Are you sure you want to clear the code?
(2)
Click on the YES button to clear the code from the list.
STEP 8.
To run the Diagnostic Tests, click on the pull down menu for Diagnostics, then select Diagnostic
Tests (Figure 3).
a. The Diagnostics Tests can run the following tests:
(1)
Injector Solenoid Test
(2)
Injection Actuation Pressure Test
(3)
Override Parameters
(4)
Cylinder Cutout Test
(5)
Wiggle Test
b. Select the test called out in the troubleshooting work package and follow the on screen
instructions.
0012-7
