ARMY TM 9-6115-672-14
AIR FORCE TO 35C2-3-444-32
MARINE CORPS TM 09244A/09245A-14
4-111
d. Installation.
CAUTION
DCS load sharing synchronizer is connected to backplane module by a multi-
pin electrical connector. Use care to push DCS load sharing synchronizer
straight onto backplane module to avoid damage to electrical connector.
Failure to comply can cause damage to equipment.
(1)
Carefully align DCS load sharing synchronizer (5, Figure 4-15) with electrical connector on
backplane module (20), and press module connector into backplane connector.
(2)
Secure DCS load sharing synchronizer (5) to DCS control box rear panel and backplane module
(20) with lockwashers (4), washers (2), screws (3), and locknuts (1).
(3)
Disconnect ESD wrist strap, and remove wrist strap.
(4)
Install DCS control box top panel, paragraph 4.7.2.
(5)
Connect negative battery cable to battery, and close BATTERY ACCESS door.
4.8.22 DCS Speed Control Unit A3.
CAUTION
Electronic components containing printed circuit boards are extremely
sensitive to electrostatic discharge (ESD). Wear an ESD wrist strap connected
to ground whenever coming in contact with ESD-sensitive components. Failure
to comply can cause severe damage to equipment.
a. Inspection.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Attach ESD wrist strap and connect to ground.
(4)
Inspect DCS speed control unit (8, Figure 4-15) for loose or missing mounting hardware and any
obvious damage.
(5)
Disconnect ESD wrist strap, and remove wrist strap.
(6)
Install DCS control box top panel, paragraph 4.7.2.
b. Testing.
(1)
Shut down generator set, paragraph 2.11.2.
(2)
Remove DCS control box top panel, paragraph 4.7.2.
(3)
Start generator set, paragraph 2.11.1.
