ARMY TM 9-6115-670-14&P
2-1
CHAPTER 2
OPERATING INSTRUCTIONS
Page
Section I
Description and Use of Operator Controls and Indicators .......................................
2-1
2.1.
APU Control Unit .....................................................................................
2-1
Section II
Operator's Preventive Maintenance Checks and Services (PMCS)........................
2-4
2.2.
Introduction to Operator PMCS Table......................................................
2-4
Section III
Operation Under Usual Conditions..........................................................................
2-12
2.3.
Assembly and Preparation for Use ..........................................................
2-12
2.4.
Preoperational Checks ............................................................................
2-12
2.5.
Operating Procedures..............................................................................
2-12
2.6.
Shut-Down...............................................................................................
2-13
Section IV
Operation Under Unusual Conditions......................................................................
2-14
2.7.
Operation in Arctic Climate ......................................................................
2-14
2.8.
Operation in Desert Climate.....................................................................
2-14
2.9.
Operation in Tropical Climate ..................................................................
2-15
2.10.
Operation in Salt Air or Sea Spray...........................................................
2-15
2.11.
Nuclear, Biological, and Chemical (NBC) Decontamination Procedures .
2-15
Section I. DESCRIPTION AND USE OF OPERATOR CONTROLS AND INDICATORS
2.1. APU CONTROL UNIT.
This section describes operator controls and indicators for the APU. All controls and indicators for the
APU are located on the front panel of the control unit (Figure 2-1). Function or use of the controls and
indicators is contained in Table 2-1.
NOTE
Refer to “Table 1-1. Differences Between Models.”
for differences between MEP-903A, MEP-903B and
MEP-903C, which may not be depicted in the TM
illustrations.
