e.
Remove nut (4), serrated lock washer (5), washer (6), and teflon washer (7).
f.
Remove screw (13), washer (12), cable (14), and nut (10) from front cable connector (8).
g.
Slide resistor R3 (11) as far forward as possible and remove screw (13), lock washer (12), cable
(14), and nut (10) from rear cable connector (9).
TM 9-6115-669-13&P
h. Remove resistor R3 (11).
Use a multimeter to check the resistance.
Resistance must be 7.4 Ohm.
CAUTION
The resistor is made of ceramic. Be careful not to damage it during
installation.
a.
Install cable (14) on rear cable connector (9) of resistor R3 (11) and secure with screw (13), lock
washer (12), and nut (10).
b. Install cable (14) on front cable connector (8) and secure with screw (13), lock washer (12), and
nut (10).
c.
Install teflon washer (7), washer (6), serrated lock washer (6), and nut (4).
d.
Refer to paragraph 5.10 and install cables 119 through 127 on power contactor K4, K5, K6.
e. Remove stanchion.
f.
Stow prop (3) close access door (2) and secure.
g.
Install stanchion by PDU (1).
4-92
