TM 9-6115-669-13&P
Section IV. OPERATION UNDER UNUSUAL CONDITIONS
WARNING
Potential 150 kw/208 VAC shock hazard with failure to adhere to this
warning. Contact with this high power could result in death or
severe injury, If the removal of one generator from the EPP III is
required, replace it with an extra generator if available. If the EPP
III must be operated with only one generator installed, insure that
all cables for the removed generator have the protective caps
properly installed prior to starting the remaining generator set.
If operation of one of the EPP III generators when the other
generator is dismounted is required, protective covers must be
installed on power cable connectors L1, L2, L3 and N.
Prior to energizing the equipment the operator must check for
exposed electrical terminals.
Always install protective covers on control and power cables when
cables are not connected.
Be sure to observe all Warning labels on equipment.
Potential 208 VAC shock hazard. Do not disconnect or connect
control or power cables while generator set 1 or 2 is running.
WARNING
Do not operate Generator Set 150 kW unless it is properly
grounded and all load terminals are not shorted. Failure to
observe this warning can result in severe personal injury or
death.
N O T E
Before operating Generator Set 150 kW, all connections must be made
to the EPP III PDU. See also kW Short Operating Instructions plate.
2.9 OPERATING GENERATOR SET 150 KW.
N O T E
The MASTER SWITCH is a five position switch:
Position One
-
Locked and Gen Set 150 kW will not run in this position.
Position Two
-
Off with the key fully inserted (pushed in); Gen Set 150
kW will run in this position but cannot be started.
Position Three
-
Off with the key in the half-way inserted position; this is
the “NORMAL” shut down position.
Position Four
-
Switch is on with key fully inserted; this is the “NOR-
MAL” start and run position.
Position Five
-
Switch is on with key inserted half way; this is the
EMERGENCY shut down position.
2 - 70
Change 1
