TM 9-6115-664-13&P
4-54. STARTER MAINTENANCE
This task covers removal, inspection, and installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment, Automotive Maintenance
APU Cover Assembly Removed (Para. 4-12)
and Repair (Item 1, App. B)
Engine Start Solenoid Removed (Para. 4-45)
A.
REMOVAL.
NOTE
Discard and replace all lockwashers
and locknuts when removed.
1.
Pull back rubber boot (1, Figure 4-44) to expose wire
lug (2). Remove nut (3), lockwasher (4), and washer
(5).
2.
Tag electrical wire (6). Disconnect wire from starter
by removing screw (7).
3.
Remove starter (8) from engine by removing screws
(9, 10).
4.
Remove bushing only if damaged. Remove by
driving out of crankcase using a hammer and punch.
B.
INSPECTION.
1.
Inspect starter for obvious damage. Inspect for
corrosion and signs of electrical short. Inspect
starter shaft for damage.
2.
Inspect
bushing
in
crankcase
for
scoring,
deformation, or excessive wear.
3.
Inspect electrical wires for cuts, abrasions, bare
wires, or corrosion. Inspect wire insulation for
damage.
Figure 4-44. Engine Starter (Sheet 1 of 2)
4-123
